Training Mode; Instructions For Maintenance; Power Supply And Interfaces; Cleaning - QUORION QMP 2000 series User Manual

12. Training Mode

The training mode is used to test all functions of the QMP 2000 without adding the turnover to the reports.
The report memory will not be changed and all counters remain constant. Please note that in this mode all
receipts will be automatically marked as „Training".
In order to access the training mode, a pre-programmed training clerk must be signed-in. Training mode
will remain activated until a new clerk is assigned. You will have full access to all registration and
programming functions for testing and training purposes.

13. Instructions for maintenance

The QMP 2000 does not contain any components, which can be serviced or repaired by the user. Please
have all maintenance performed by a qualified QUORION dealer. Unauthorized manipulations may lead to a
loss of warranty.

13.1 Power Supply and Interfaces

Please use the delivered power supply for the QMP 2000 only. The usage of other power supplies may
damage your POS system. No liability is accepted for such damages.
The interface connections should only be plugged if the system is switched off. Please note also the
maximum cable lengths of 5 meters for USB and 15 meters for RS232.

13.2 Cleaning

To clean your QMP 2000 please use a lint-free dry or slightly damp cloth only. Disconnect the system from
the power supply before cleaning. Do not use any abrasive substances or agents containing solvents.
Special caution is required when cleaning the display. Be careful not to scratch the surface and prevent any
liquids from entering the housing.
In case of heavy pollution you may also use a damp cloth to clean the touch surface. Please use only warm
water or a special screen cleaner to damp the cloth. Never put the liquid directly on the screen, but only on
the cloth. The cloth should only be damp, but not wet!
45