St. Croix SCR Installation & Operation Manual page 61

8. Are there any adjustments that can be made, through the control board, to the amount of
fuel that is fed into the burnpot?
Answer: There are several ways to adjust the amount of fuel that is
fed into the burnpot. The feed rates can be fine-tuned while the
Stove is in operation by pressing and holding the "Auger Feed"
button down and then either pressing and releasing the "Heat
Level High" button to advance the feed rate higher, or pressing and
releasing the "Heat Level Low" button to decrease the feed rate.
There are 5 levels on the control board and they are indicated by a
single flash of the LED's. The default setting is the center LED.
This gives 2 adjustments increasing the feed rate (LED's 4 & 5)
and 2 adjustments decreasing the feed rates. (LED's 1 & 2) The
ON time is increased or decreased .25 seconds with each
adjustment.
9. Are there any adjustments that can be made, through the control board, to the Combustion
Fan voltages to help adjust the draft?
Answer: The Draft can be adjusted in a similar fashion as mentioned in
the previous example.
The Fan voltages can be fine-tuned while the Stove is in operation
by pressing and holding the "Auger Feed" button down and then
either pressing and releasing the "Draft Trim High" button to
advance the voltages higher, or pressing and releasing the "Draft
Trim Low" button to decrease the fan voltages.
There are 5 levels on the control board and they are indicated by single
flash of the LED's. The default setting is the center LED. This gives 2
adjustments increasing the voltage (LED's 4 & 5) and 2 adjustments
decreasing the voltage. (LED's 1 & 2) The voltage is increased or
decreased 2.5 volts with each adjustment.
Lincoln SCR Manual
61
Figure 29
Figure 30