Changing The Program On The Control Board - St. Croix SCR Installation & Operation Manual

Damper setting for Pellets, Cherry Pits & Distiller's Grain - Use the Factory Setting as the
beginning point for final Damper Adjustments.
Damper setting for Corn - Turn the Screw in 1.5 turns from the Factory Setting and make sure
the damper blade rests against the setscrew. (This is reversing the screw a total of 3.5 full turns if
the screw is turned in until it stops). Return to the Factory setting if you have difficulty
starting the unit.
Damper setting for Wheat & Rye - Turn the Screw in 3 turns from the Factory Setting
and make sure the damper blade rests against the setscrew. (This is reversing the screw a
total of 2 full turns if the screw is turned in until it stops)
you have difficulty starting the unit.
FOR MORE INFORMATION ON FINE-TUNING THE DAMPER SEE PAGES 41 - 44
"COMBUSTION AIR DAMPER"
Figure 26
The factory setting is achieved by turning the
screw in until it stops and then reversing the
screw 5 full turns.
handle to place the damper against the
screw
When switching between fuels it is best to
return the Damper to the Factory Setting and
then proceed to the setting listed below.
Remember: The Settings listed below are the
starting point for final adjustments to the
damper and are for reference only.
Figure 25

Changing the Program on the Control Board

To change the program the Stove must be in the OFF position, the
Stove must be cooled down so the Proof of Fire switch is open
and the Thermostat slide switch must be in the Manual mode. (See
figure 26)
Press & hold Auger Feed Button, then press & release the Draft
Trim High & Low Buttons. The LED lights that indicate the heat
level will flash. The number of times the lights Flash will indicate
which program is running.
Program 1 – LED lights flash once
Program 2 – LED lights flash twice
Program 3 –LED lights flash three times
Program 4 – LED lights flash four times
Lincoln SCR Manual
39
Remember to use the
.
Return to the Factory setting if