St. Croix SCR Installation & Operation Manual page 6

How to fix the problem if it happens?
If this happens, first unplug the unit and use a vacuum to clean out the fuel or ash in the pot. To
clear a foreign object may require reversing the motor by hand. Figure 1 shows how to access the
area where the Switches and Revolution gearmotor are located.
Figure 2
Keep an eye on the 2 switch levers
shown in figure 2. They eventually
will end up against the end of the
notches shown in figure 3. Rotating
any further than that will bend the
levers and potentially damage the
switches.
To clear a jam will usually only
require the drum to be reversed a
small amount for the object or the
fuel to free up.
Figure 3
Once the jam has been cleared, simply plug the unit back in and the drum will rotate through
and stop in the correct position.
Lincoln SCR Manual
6