Module Installation (2-Port, 3-Port, 4-Port) - Paramount Fitness PCC2000 Owner's Manual

WATER VALVE INSTRUCTIONS
Module Installation & Alignment Guide (2-port,
3-port, 4-port)
1. Check the o-ring and groove for debris and clean if necessary
(this is a quad ring and is almost square, the height is slightly
bigger than the width).
2. Replace the o-ring (Part # 005-302-0100-00) if it is stretched or
damaged. The o-ring does not require any lubrication. Lubricating
o-ring can attract dirt and debris that could prevent it from sealing.
Never use petroleum jelly on plastic or rubber parts, as this will
damage them.
3. The module should fit in the base without forcing it. If it doesn't
seat easily then check the following.
• 2-port module alignment – on the 2-port module the ports
on top of the module that are attached together by tubes
must be centered over the open ports in the valve base
(Figure 5).
• 3-port module alignment – on the 3-port module the ports
on top of the module that are attached together by tubes
must be aligned over an open port and a closed port sec-
tion (Figure 5).
• 4-port module alignment – on the 4-port module the ports
on top of the module that are attached together by a tube
11
(CONT.)