How To Close The Water Valve - Paramount Fitness PCC2000 Owner's Manual

WATER VALVE INSTRUCTIONS

How to close the water valve

1. Check the o-ring and groove for debris, and clean if necessary
(this is a quad ring and is almost square, the height is slightly big-
ger than the width)
2. Replace the o-ring if it is stretched or damaged. The o-ring does
not require any lubrication. Lubricating The o-ring can attract dirt
and debris that could prevent it from sealing. Never use petroleum
jelly on plastic or rubber parts, as this will damage them.
3. Place the run/pause switch in the run position then install the
valve top onto the base. The lid may be rotated in any direction
for easy viewing of pressure gauge.
4. Place the band clamp around the valve shells and put the clamp
knob or 7/16 nut on the threaded bolt.
5. Tighten the knob/nut securely. Note: Gently tap the band clamp
starting opposite the knob/nut going around both sides. While
periodically tightening the knob/nut. Be careful not to over tighten
the knob/nut.
6. Turn on the pump and inspect the water valve for leaks.
CAUTION! NEVER stand over any pool equipment when starting
the pump after working on it.
7. If you find leaks, turn off the pump and tighten the band clamp
more. If it continues to leak, repeat the above steps. If this doesn't
work, replace the o-ring.
14
(CONT.)