WATER VALVE INSTRUCTIONS
(CONT.)
The Run/Pause control switch
The run/pause control switch
Figure 6
is used to stop the cleaning
system circuits from cycling.
When switched to the pause
position, it will stop on the
circuit that is up at that time.
The run/pause control switch
should only be used when you
desire the nozzles not in the
up position to remain down or
while servicing the system.
Note: The run/pause control switch can be used without turning
off the pump, but can cause damage to the water valve or module
diaphragms if overused. If you frequently use the run/pause control
switch you should turn off the pump first. Always turn the run/pause
control switch to the run position when removing and replacing the
water valve lid.
15