Paramount Fitness SwingJet Installation Manual

FIG. 1
NOTCHES
NOZZLE
SWINGJET TOOL
FIG. 2
TO REMOVE
FIG. 3
RETAINER
INSTALLATION GUIDE:
SWINGJET
1. NEW SWING JET
RAISED AREA
www.1Paramount.com
The swing jet comes packed with the cover
•
off.
Push the nozzle up and look and feel for
•
the raised area on the side of the colored
nozzle that is in the center of the cream
colored Cam. (Fig 1). The nozzle jet open-
ing is 180 degrees opposite that raised
area. Push the nozzle shaft up and down
until the nozzle jet is either all the way right
or all the way left so when you are doing
the next two steps you are aware of which
direction it is going to travel when rotating.
There are three notches in the cream col-
•
ored cam above the raised area (Fig 1).
These cam notches are in a straight line
with the cam notches on the opposite side
of the raised area. The jet opening of the
nozzle goes back and forth covering the
90 degree arc formed by the three ratchet
positions as the nozzle extends and retracts
when cycled.
• Put one wrap minimum of Teflon tape on
the threads to make the nozzle threads not
seize up over time, and thread the swing
jet in the return fitting tight, using the swing
jet installation and removal tool. It should
be tight enough so it can not be turned by
hand. Hand tighten only, NEVER USE A
WRENCH DIRECTLY ON THE SWING JET.
ALWAYS REMOVE THE COVER AND USE
THE TOOL (Fig 2 & 3) (AVAILABLE FROM
PARAMOUNT 005-721-4541-00) TO COV-
ER THE SWING JET RETAINER BEFORE
USING A WRENCH TO REMOVE THE
SWINGJET.
1.800.621.5886