Nozzle Removal/Installation - Paramount Fitness PCC2000 Owner's Manual

NOZZLE REMOVAL /INSTALLATION
Nozzles may need to be removed from time to time for purposes of
winterizing or to flush debris from the lines and/or nozzles. There are
3 methods of removing the 8 different types of nozzles.
Method 1:
For Vanquish, Vantage and PCC2000 floor nozzles see Figure 7.
Using the removal tool common to these nozzles, attach the tool to
the end of your pool pole placing it over the nozzle and making sure
the tool tabs insert into the nozzle slots. Turn the tool clockwise a ¼
turn to unlock the nozzle and then lift it from the body in the floor of
the pool. When replacing the nozzle, be sure the body is free from
all debris or the nozzle will not lock in place. Make sure the o-ring on
the bottom of the nozzle is in place. Lock the nozzle into the tool on
the end of your pool pole and replace the nozzle in the body and turn
counter clockwise to lock into the body.
NOTE: Sand and pebbles can get between the body and the nozzle
and make it very difficult to remove a nozzle. To make the nozzle re-
moval easier, use a pressure nozzle on a garden hose (like you use to
clean the side walk) and blow the debris out between the nozzle and
body before using the tool to
remove the nozzle.
NOTE: The nozzle is specific
to the body it came out of.
Always put the nozzle back in
the same body it came out of.
Part Number: Vantage 004-602-5440-00, Vanquish 004-577-5440-00, PCC
004-552-5440-00
17
Figure 7
Part Number: 004-552-5440-00