Operating Instructions - Paramount Fitness PCC2000 Owner's Manual

OPERATING INSTRUCTIONS

1. On all Paramount in-floor cleaning and circulation systems it is
important to keep the skimmer, the pump and the debris canister
baskets clean. It is also important to clean your filter when the
pressure rises 5 psi (34 kPa) over the clean starting pressure.
2. The gauge on your water valve is important and tells you how
the system is operating. Gauges can deteriorate over time and
should be replaced when they become unreadable or inaccurate.
Never use Teflon tape on a replacement gauge, use a thread
sealant that is approved for plastic such as Teflon paste. Hand
tighten gauges as over tightening can crack the water valve lid.
3. If a nozzle is stuck open or up when the pump shuts off you may
clear it by pushing down on it a few times while pump is on to
clear the obstruction.
4. No cleaning system is 100%. Paramount's in-floor guarantee
is the strongest in the industry but some attention to the pool is
required to keep your backyard oasis beautiful. You must keep
your chemicals at proper levels, and brush any small areas that
may have a build up of heavy sand or debris. Keep in mind that
when excessive debris gets into a pool, such as large amounts of
leaves in the fall or dirt during a dust storm, no cleaning system
can do the job without some help, so be sure your equipment is
maintained.
5. On PCC and Vantage systems that may have fixed nozzles they
may need to be adjusted to keep their flow of water aimed in
the direction of the debris drain. These nozzles can be turned
clockwise when in the up position by pushing down slightly and
rotating them towards the main drain.
For further instructions see troubleshooting guide (pg 27-29).
26