Troubleshooting Guide For Paramount In-Floor Systems - Paramount Fitness PCC2000 Owner's Manual

Troubleshooting Guide for
Paramount In-Floor Systems
Problem
Cleaning
nozzles(s) are
staying up when
the pump is off
Cleaning nozzles
on a circuit stay
up once the
water valve has
switched to the
next circuit but
retract when the
system is off.
It is always best to call a trained professional to service your pool
Further information on your cleaning system can be found at: www.1paramount.com
Diagnosis
Cleaning nozzles could be
jammed with sand or debris
which could result from improper
cleaning of your pool filter. See
section Paramount's systems
relationship to your pool's
equipment.
A circuit in the water valve is
staying open due to a jammed
piston in the module. This
could be caused by debris
entering the water valve.
NOTE: PCC AND VANTAGE
BOOSTER PUMP SYSTEMS
MAY HAVE FIXED NOZZLES
ON THE FILTER PUMP
WHICH STAY UP WHILE THE
FILTER PUMP IS ON.
Solution
Isolate the circuit of the jammed
or stuck cleaning nozzles using
the pause switch on your water
valve. With the system pump
running push the cleaning
nozzles down repeatedly with
your foot or pool pole.
Remove the module from the
water valve (see module removal
procedure) clean it by holding it
in the pool sideways and move
it back and forth quickly until it
is clean. If there are any pistons
in the open position, push them
shut being sure not to rotate
them. Place the module back
in the water valve (see module
installation procedure) and turn
the system pump on to determine
if the cleaning nozzles are now
functioning properly. Depending
on the age of the module, if this
does not solve the problem it
may be time to purchase a new
module.
27