NOTES:
Power indicator - LED lights when the power is applied to the camera.
•
External Device Connectors:
•
D&N - To set the D&N (day and night) function manually, connect the external switch to set the D&N terminals. Open
—
the switch for day mode, close the switch for night mode.
If you use the external D&N function, set the DAY/NIGHT option to EXT on the setup menu. See "3.3 EXPOSURE" on
page 9 for more information.
Alarm Output Terminal (ALARM OUT/COM) - Connect to the alarm input of an external device. When motion is
—
detected, 3.3 Vdc is applied to the Alarm Out - Gnd terminals.
RS-485 Communication - Connect to an external RS-485 controller.
—
HD-SDI - Connect this connector to a device such as a DVR or monitor with a HD Video function.
•
Video output connector (BNC type) - Connect this connector to a device such as a DVR or monitor with a VIDEO IN
•
connector.
Power input terminal: 12 Vdc input terminals. Observe the polarity indicated when connecting 12 Vdc power to the
•
camera.
1.2 What you need
To install the camera you will need:
C- or CS-type lens
•
12 Vdc 1 A power source
•
Mounting bracket
•
Tools for mounting the camera
•
External switch
Open (day mode)
Closed
(night node)
2 MP Full HD C-Mount Box Camera User Manual
SECTION 1: INTRODUCTION
3