Table of Contents
Advertisement
SECTION 3: CONFIGURATION SETUP
COLOR Model
AUTO / DAY / NIGHT / EXT
—
Delay: 0 ~ 255 second
—
BURST: OFF / ON
—
THRS: LOW / MIDDLE / HIGH
—
GAP: LOW / MIDDLE / HIGH
—
IR SMART Model (not used with this camera)
IR CDS Model
AUTO / DAY / NIGHT
—
Delay: ---
»
BURST: OFF / ON
»
THRS: ---
»
GAP: ---
»
SMART IR: OFF / ON. NOTE: SMART IR function only works with IR Smart Mode.
•
THRS: Set-up Smart IR turns on point. When you level up the value, Smart IR turns on in a low light condition.
—
AREA: Set up areas to control Smart IR function. When BLC mode is on, Smart IR area is following BLC area.
—
POS-X: Adjust the window X-Axis position
—
POS-Y: Adjust the window Y-Axis position
—
SIZ-X: Adjust the window X-Axis size
—
SIZ-Y: Adjust the window Y-Axis size
—
IR COMP: Compensate when IR hunting happens. When you use this function, you should put a test object around
—
30 cm form the camera. If an object is located in nearer than 30 cm from the camera and an object what could reflect
the light is in front of the camera, the camera cannot compensate a trouble of hunting.
3.4 WHITE BALANCE
AWB: Select WHITE BALANCE mode. AUTO / PRESET / MANUAL / INDOOR / OUTDOOR
•
AUTO: Automatically adjusts color according to the lighting.
—
PRESET: It is a fixed white balance mode that may be automatically readjusted only by pressing PRESET
—
10
Advertisement
Table of Contents
