Table of Contents
Advertisement
2.2 Attach the lens
The camera will accommodate a C- or CS-type lens. To attach the lens, do the following:
1.
Remove the lens mounting cap from the lens mounting ring as shown below.
Lens mounting ring
Cap
2.
Carefully screw the lens assembly clockwise onto the lens mounting ring until it is fully seated. Tighten until snug.
3.
If you installed an auto-iris lens, verify that the cable pin definitions match the lens output iris connector (see "1.1 Camera
components" on page 1) then plug the cable into the connector.
Lens mounting ring
2 MP Full HD C-Mount Box Camera User Manual
SECTION 2: INSTALLATION
5
Advertisement
Table of Contents
