Xpdl Port - Musicom Lab EFX MkIII+ User Manual

⑧
The EFX MkIII+ has an additional reverse function that reverses the
control value.
Press the PS-4 switch(TGL, toggle) to reverse 1st control value.
The display will show the current 1st control value mode, nor or rEv.
The tables below show the control value and FS contact of the normal and reverse modes.
Loop or FS turn on
nor (normal)
rEv (reverse)
⑨
Press the BANK UP switch to toggle between normal and reverse. The LED above the PS-4 switch will
flash.
⑩
Press the PS-4 switch to store the reverse function in memory. The display will show str (store) for a
moment and the LED above the PS-4 switch will stop flashing.
⑪
Follow the same procedure as
Change.
Note
* The ---. means no Control Change is transmitted.
* The nor means normal and the rEv means reverse.
* The last decimal point on the display means that the display shows a Program Change number or controller
number.
* For initial default Control Change channels and controller numbers setting, refer to page 14.

3.3.3 XPDL Port

The EFX Mk III+ Audio Controller contains a XPDL port for expression pedal input or external foot switch
input. This can be used to alter parameters(via MIDI) in effects device that offer this capability.
The MIDI Control Change Value is transmitted according to the position of expression pedal or external foot
switch.
Any passive volume or expression pedal can be used. Our recommended expression pedals are Boss FV500L
and FV300L, and our recommended external foot switches are Boss FS-5U and FS-5L.
* The EPL or ESW channel and number are global (the same for all banks/presets). you don't need to edit
these for any other banks/presets if you have already done so.
①
If you are already in the Edit Mode, press/hold the
function select) to edit the EPL or ESW for the XPDL port until
the EPL or ESW is shown on the display.
The display shows the EPL(Expression Pedal) when the expression pedal is connect to the XPDL jack.
Otherwise, The display shows the ESW(External Foot Switch) when the external foot switch is connected
or a plug is not connected to the XPDL jack.
②
Press the PS-2 switch(CH, channel) to set an EPL or ESW channel. The display will
show the EPL or ESW channel.
③
Press/hold the BANK UP or BANK DOWN switches to select a channel from 1 through 16. The LED
above the PS-2 switch will flash.
EFX MkIII+ Audio Controller User Manual
Loop or FS turn off
127 (0x7F) 0 (0x00)
0 (0x00) 127 (0x7F)
① ⑩
~ to set from 2nd MIDI Control Change through 12th MIDI Control
nor (normal)
rEv (reverse)
FS-1 switch(FS,
FS Contact
Normally - Open
Normally - Closed
9