Editing Xpdl Port - Musicom Lab EFX MKII User Manual

* The CCs channel and number are global (the same for all banks/presets). you need not edit
these for any other banks/presets if you have already done so.
①
Press/hold the PS-1 switch(FS, function select) to edit the
display if you are already in the Edit Mode.
②
Press the PS-2 switch(CH, channel) to set a
CC1 channel.
③
Press/hold the BANK UP or BANK DOWN switches to select a channel from 1 through 16.
④
Press the PS-2 switch to store a new
switch will flash 2 times.
⑤
Press the PS-4 switch(CC, control change) to set
current CC1 number.
⑥
Press/hold the BANK UP or BANK DOWN switches to select a
127 or OFF.
⑦
Press the PS-4 switch to store a new
switch will flash 2 times.
⑧
Follow the same procedure
Note
* The OFF means no Control Change is transmitted.
* The last decimal point on the display means that the display shows a PCs or CCs number.
* The Initial default channel settings of the CCs are channel 1.
* The Initial default number settings of the CCs are OFF.
3.3.3 Editng XPDL Port
The EFX Mk II contains a XPDL port for expression pedal input. This can be used to alter
parameters(via MIDI) in effects device that offer this capability.
The MIDI Control Change Value is transmitted corresponding to the position of expression pedal.
The Control Change value is from 0 through 127 when the position of expression pedal is from
minimum through maximum. Any passive volume or expression pedal can be used. Recommended
pedals are Boss FV500L/H, FV300L/H, FV200 and FV100.
EFX MkII Audio Controller User Manual
CC1 channel. The display will show a current
CC1 channel in memory. The LED above the PS-2
CC1 number in memory. The LED above the PS-4
① ⑦
~ to set from CC2 through CC8.
CC1 until the CC1 is shown on the
CC1 number. The display will show a
CC1 number from 0 through
8