Midi Control Change - Musicom Lab EFX MkIII+ User Manual

⑤
Press the PS-2 switch to store a new PC.1 channel in memory. The display will show str (store) for a
moment and the LED above the PS-2 switch will stop flashing.
* The PC.x channel is global (the same for all banks/presets). You don't need to edit this for any other
banks/presets if you have already done so. In this case, omit procedures
⑥
Press the PS-3 switch(NUM, number) to set a PC.1 number. The display will show the
current PC.1 number.
⑦
Press/hold the BANK UP or BANK DOWN switches to select a PC.1 number from 001. through 128. or
---.. The LED above the PS-3 switch will flash.
⑧
Press the PS-3 switch to store a new PC.1 number in memory. The display will show str (store) for a
moment and the LED above the PS-3 switch will stop flashing.
⑨
Press the PS-1 switch(FS, function select) to set other PC.x and follow the same procedure as
Note
* The ---. means no Program Change is transmitted.
* The last decimal point on the display means that the display shows a Program Change number or controller
number.
* For initial default Program Change channels and number settings are refer to page 14.

3.3.2 MIDI Control Change

The MIDI Control Changes are transmitted via the MIDI OUT jack when the assigned loops or function
switches turn on or off. The LP.1 is assigned the Loop1, ... , and the FS.4 is assigned the Function Switch 4.
* The Control Change channel and controller number are global (the same for all banks/presets). You don't
need to edit these for any other banks/presets if you have already done so.
①
If you are already in the Edit Mode, press/hold the
edit the 1st Control Change until the LP.1 is shown on the display.
②
Press the PS-2 switch(CH, channel) to set a 1st Control Change channel. The display will show the current
1st Control Change channel.
③
Press/hold the BANK UP or BANK DOWN switches to select a channel from 1
through 16. The LED above the PS-2 switch will flash.
④
Press the PS-2 switch to store a new 1st Control Change channel in memory.
The display will show str(store) for a moment and the LED above the PS-2 switch will stop flashing.
⑤
Press the PS-3 switch(NUM, number) to set 1st controller number. The display will show the current 1st
controller number.
⑥
Press/hold the BANK UP or BANK DOWN switches to select a 1st controller number
from 000. through 127. or ---.. The LED above the PS-3 switch will flash.
⑦
Press the PS-3 switch to store a new 1st controller number in memory.
The display will show str (store) for a moment and the LED above the PS-3 switch will stop flashing.
EFX MkIII+ Audio Controller User Manual
③ ⑤
~ .
PS-1 switch(FS, function select) to
③ ⑧
~ .
8