Control The Pedal Switcher; Power Requirement - Musicom Lab EFX MkIII+ User Manual

①
If you are already in the Edit Mode, press/hold the
set the popping noise reduction control until the Pr.2 is shown on the display.
②
Press/hold the BANK UP switch to set a popping noise reduction control from Pr.0
through Pr.4.
It will automatically be stored in memory when you return to Preset Mode.
Pr0 means the popping noise reduction control is not used.
⋮
Pr4 means the maximum of the popping noise reduction control.
Note
* The initial default setting is Pr.2.

3.3.8 Control the Pedal Switcher

When you need more audio loops, you can use the Pedal Switcher of Voodoo Lab. The Pedal Switcher
accepts only MIDI SysEx messages. The EFX MkIII+ can transmit these messages.
①
If you are already in the Edit Mode, press/hold the
to control the Pedal Switcher until the PS.F is shown on the display.
②
Press the BANK UP switch to select PS.n.
③
Press the MODE switch to store the function and return to Preset Mode.
④ Select the preset to be programmed in the Preset Mode.
⑤
Press the MODE switch to enter the Instant Access Mode. The display will show:
And the 4 LEDs above PS-1 ~ PS-4 switches will indicate the corresponding Loop1 ~
Loop4 as on or off.
⑥
Activate all the Pedal Switcher loops you want.
⑦
Press the BANK UP switch to store the edit and return to Preset Mode, or press the BANK DOWN switch
to return to Preset Mode without storing the edit.
⑧
Follow the same procedure as
Note
* The PS.F and PS.n mean Pedal Swither On and OFF.
* The initial default setting is PS.F.
* EFX MkIII+ can control 128 presets for the Pedal Switcher.
⋅
(from bank 1 preset 1 to bank 32 preset 3 and global preset)
4. Power Requirements
The EFX MkIII+ Audio Controller requires a regulated 12VDC or 9VAC at approximately 250mA. The power
jack is a standard 5.5mm/2.1mm barrel.
The EFX MkIII+ Audio Controller can also be powered from outputs 5 or 6 of the Voodoo Lab Pedal Power 2
Plus. You must set the corresponding DIP switch away from the normal position.
EFX MkIII+ Audio Controller User Manual
PS-1 switch(FS, function select) to
PS-1 switch(FS, function select)
④ ⑦
~ for any other presets you want to program into the Pedal Switcher.
⋅
13