Powering On The Pdt 7500 - Symbol PDT 7500 Series Product Reference Manual

2. Tap the center of each target that appears on the screen with the tip of the stylus.
3. Tap the screen to continue.
The Symbol shell and Launcher program are deployed.
Note: If the digitizer fails to respond, call the Symbol Support Center for
assistance.

Powering on the PDT 7500

Because the terminal is battery powered, it is important to save power whenever possible. You
can minimize power loss and increase battery life by turning the terminal off when data is not
being entered.
While the terminal's processor and display are off, programs or data in the system's memory
are retained. Before the terminal powers up, it checks the batteries for enough power to
ensure reliable operation and data storage. Power-up restores the display, and processing
continues from where it was before power-down.
To power on the PDT 7500:
1. Make sure a fully charged battery is installed in the terminal.
2. Press the Power key
To suspend the PDT 7500's operation, press the Power key again.
Figure 3-2. Calibrating the Screen
.
Using The Terminal
3-3