Switching The Illumination Lamp Setting; Turning The Illumination Lamp Off; Turning The Illumination Lamp; Setting The Auto Standby Mode - Marantz PM-14S1 Owner's Manual

Switching the illumination lamp
setting
The illumination lamps on the both sides of the unit main panel
can be turned on or off.
The illumination lamp is set to on in the factory default
settings.

Turning the illumination lamp off

Press and hold DISPLAY on the unit for 2 seconds
or longer.
The illumination lamps turn off.
Turning the illumination lamp on
Press and hold DISPLAY on the unit for 2 seconds
or longer.
The illumination lamps light.

Setting the Auto Standby mode

You can set the unit to automatically switch to standby mode
if the unit is not operated for 30 minutes when there is no
audio input.
Auto Standby mode is set to on by default.

Turning Auto Standby mode off

Press and hold TONE on this unit for 5 seconds or
longer.
"AUTO STBY OFF" appears on the display.
Turning Auto Standby mode on
Press and hold TONE on this unit for 5 seconds or
longer.
"AUTO STBY ON" appears on the display.
This unit will automatically enter standby mode after about
continuous 30 minutes in the following conditions.
No operation performed on the remote control.
No operation of this unit.
The display will show the remaining time for three minutes
before the units enters standby mode.
In F.C.B.S. connection, only the ID 1 master unit activates
Auto Standby mode. If the ID 1 master unit is operated with
no audio input, set the Auto Standby mode to off.
ENGLISH
19