Operations; Turning The Power On; Turning The Power Standby; Switching The Illumination Lamp On/Off - Marantz MM8077 Owner's Manual

Operations

ON/STANDBY DISPLAY
STANDBY Protection Power
indicator indicator indicator

Turning the power on

When the power is in standby, press
• The protection indicator fl ashes for approximately 7 seconds, and
the power switches on.
• The power indicator lights.
NOTE
When turning the power ON, turn the volume control of connected
devices down to the minimum.

Turning the power standby

When the power is in power on, press
The STANDBY indicator lights, and the power changes to standby.
NOTE
Even if the unit is switched to standby, some of the circuits are still
active. If you will not be using this unit for a prolonged period (due to a
holiday etc), remove the power plug from the wall socket.
Furthermore, to prevent unexpected accidents, make sure the power
plug is located where it can be removed at any time.
Switching the illumination lamp
ON/OFF
.
ON/STANDBY
If the unit is being used with the factory settings, the illumination lamp
lights.
You can turn the illumination lamp off if it is making the room too
bright at nighttime.
Press DISPLAY
Each time this button is pressed, the illumination lamp turns ON/
OFF.
Setting the power to standby
.
ON/STANDBY
automatically
( Auto standby function)
When the auto standby function is set to ON, if there are no signals
input into this unit and no operations are performed for more than 30
minutes, the power of this unit automatically switches to standby.
• The factory setting is "ON".
Press
DISPLAY
The auto power off display switches as shown below according to
the auto standby function.
• When the auto standby function is ON: Lit
• When the auto standby function is OFF: Off
NOTE
When performing the "Setup Assistant" or "Speaker Setup" function
on AV7701 or AV8801 that is used together with this unit, set the auto
standby function to "Off" on this unit.
ENGLISH
.
for more than 5 seconds.
9