Connections; Cables Used For Connections; Connecting The Speakers; Connecting The Speakers Cables - Marantz PM-14S1 Owner's Manual

Connections

NOTE
Disconnect this unit's power plug from the power outlet before connecting the speakers.
Connect the speaker cables so they do not stick out of the speaker terminals. The protection
circuit may be activated if the wires touch the rear panel or if the + and – sides touch each
other (vpage 24 "Protection circuit").
Never touch the speaker terminals while the power cord is connected. Doing so could result
in electric shock.
Use speakers with an impedance of 4 – 8 Ω/ohms.

Cables used for connections

Provide necessary cables according to the devices you want to connect.
Speaker cable
Audio cable
Remote connector cable
L L
R R

Connecting the speakers

Connecting the speakers cables

Carefully check the left (L) and right (R) channels and + (red) and – (white) polarities on the
speakers being connected to the unit, and be sure to connect the channels and polarities
correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the tip of
the speaker cable, then either twist the core wire tightly or
apply solder to it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable's core wire to all the way into the
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
Spade lug connector
ENGLISH
When using a banana plug
Tighten the speaker terminal firmly
before inserting the banana plug.
7