Table of Contents
Advertisement
Changing the Filter Cartridges
Your system is equipped with valved heads which will automatically turn off the water supply to each filter when the fil-
ter is released, thus you do not need to turn off the incoming water supply at the Adapt-a-Valve. The faucet must be off
when filters are replaced. To make the removal of the filter cartridges easier, the heads & cartridges may be swiveled
up to 90 degrees.
6 Month System Maintenance
Replace:
Sediment
LVOC Carbon Block
Annual System Maintenance
Replace:
Sediment
LVOC Carbon Block
UF Membrane
Step 1:
Place a towel under the filter module to catch any excess water that may
drip out from the filters during the changeover.
Step 2:
To remove a filter cartridge: Push & hold the button on the valved head
above the filter. Pull cartridge downward (from the head) to remove.
Release button and discard old filter.
Step 3:
To install a filter cartridge: Remove the seal cap and insert the cartridge into the valved head until you
hear an audible "click" (the button does not need to be pressed to install new filters).
If the new filter cartridge won't snap in easily or pops off it may be due to high incoming water pres-
NOTICE
sure. Relieve pressure to the system by turning off the water supply using the adapt-a-valve and then
install the cartridge. Once the cartridge is seated, turn the water supply back on to your unit.
(PN# 105311)
(PN #105371)
(PN# 105311)
(PN #105371)
(PN# 105321)
Page 10
PRESS
PULL
Advertisement
Table of Contents
