Table of Contents
Advertisement
LOG PLACEMENT
Before you begin — This unit is supplied with six (6) ceramic fiber logs. Do not handle
these logs with your bare hands. Always wear gloves to prevent skin irritation from
ceramic fibers. After handling the logs, wash your hands gently with soap and water to
remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation of
this heater. Sooting and other problems may result if the logs are not
properly and firmly positioned in the appliance. Never add additional
logs or embellishments such as pine cones, vermiculite or rock wool
to the heater. Only use the logs and TPB-RW (rock wool) supplied with
the unit.
Failure to position the parts in accordance with diagrams below or to use
only parts specifically approved for this heater may result in property
damage or personal injury.
INSTALLING BLAZING OAk LOGS ON BURNER
1. Place right base log (#1) on two
pins located on the right side of
the grate. Figure 19
2. Place rear log (#2) on two pins
on back of grate allowing the
right end of the rear log to rest
on top of the right top log. Fig-
ure 20
Figure 19
Pins
Figure 20
23D8036
Right Base
Log #1
Rear Log #2
LG931
ISDG right base log
33ISDG Vent Free Gas Fireplace System
Right Base
Log #1
Pins
LG932
LG933
17
Advertisement
Table of Contents
