Log Placement - Majestic 20iLDVNV Installation And Operating Instructions Manual

20/30/40ILDV Fireplace Insert
Before you begin - This unit is supplied with six (6)
ceramic fiber logs. Do not handle these logs with your bare
hands. Always wear gloves to prevent skin irritation
from ceramic fibers. After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
iNStALLiNG LOGS AND ROcK WOOL
(eMBeR MAteRiAL) iN FiReBOx
1. Break up rock wool (ember material) into dime-sized
pieces. Place evenly as shown. Do not exceed 1" layer
covering all round burner ports. Refer to Figures 16a
and 16b.
2. Do not cover rectangular slots located at rear of
burner.
Do not use the entire
bag of rock wool to
cover burner area.
Figure 16a -
Ember Material Area
Figure 16b -
Place Ember Material
18
Ember Material Area
Ember Material
LG536
ILDV
the positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones or
vermiculite to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may re-
sult in property damage or personal injury.
FP1968
ember material area
9/08

LOG PLAceMeNt

FP1968
LG536
83D0524