Table of Contents
Advertisement
33ISDG Vent Free Gas Fireplace System
This fireplace has a three-prong, grounded
electrical plug. This plug helps protect
you against electrical shock. Only connect
plug to a properly grounded, three-prong
receptacle. Do not cut or remove the
grounded prong from this plug.
IMPORTANT: Always check local building codes. The installation must comply with local
regulations as well as the national electric codes.
If any of the original wire as supplied with the fireplace must be replaced, contact dealer for
proper replacement wiring harness. (Refer to parts list for correct part number). 120 volts, 60Hz,
1 amp.
Electrical power cord (plug) can be routed to exit the ISDG on either the left side or the right
side. Remove cord protector from side of unit, route power cord through hole opposite side.
Reinstall cord protector.
110/115
V.A.C.
Figure 18 -
DIS Wiring Diagram
16
Fan Switch
OFF
Black
ON
White
Green
FP2783
DIS wiring
ELECTRICAL WIRING - FAN
Never attempt to service heater while it is
plugged in, operating, or hot. Burns and/or
electrical shock could result.
Thermostat
Control
Black
Blower
Motor
23D8036
Advertisement
Table of Contents
