Table of Contents
Advertisement
FINAL INSTALLATION
WALL FINISHING
Combustible Materials: Materials made of, or surfaced with wood, compressed paper, plant fibers or
other materials that are capable of being ignited and burned. Such materials are considered combus-
tible even though flame proof, fire retardant, treated or plastered.
Noncombustible Materials: Materials which will not ignite and burn. Such materials are those consist-
ing entirely of steel, iron, brick, tile, concrete, slate, glass, marble or combinations thereof, or have a
UL Fire rating of Zero (0).
High Temperature Sealant Material: Sealant that will withstand high temperatures; General Electric
RTV103 or equivalent.
FINISHING THE FIREPLACE FLUSH WITH A WALL
When finishing the face of the fireplace, combustible material may be brought up to the side or top edge
of the fireplace, but must never overlap the black metal face. The black metal face may be covered
with noncombustible material only. After applying the finishing material, a noncombustible sealant, 1/8"
minimum, should be used to close off any gaps at the top and sides between the fireplace and the
finishing to prevent cold air leaks. Refer to Page 10, Figure 6, for allowable locations for combustible
materials.
ROCK WOOL PLACEMENT
Rock wool should be evenly covering the burner from front to back. The rock wool should be separated
into chunks about the size of a nickel. The bag supplied has an excess of rock wool. The remaining
may be sued as filler over time.
LAVA ROCK PLACEMENT
Sprinkle a thin layer of lava rock on the floor of the inner chamber. Do not pile up in any area. It should
be placed in a single layer only around but not on any portion of the burner.
Do not sprinkle the lava rock or ember
chunks on top of the burner. This may
cause potential sooting, glass breakage
and a fire hazard.
LOG PLACEMENT
VDY24/18D3R
1. Align pins on bottom of Rear Log #1 with pins on grate bar and
place on grate.
2. Place Front Left Log #2 on left front of grate bar aligning cutout
in bottom of log with grate bar.
3. Place Front Right Log #3 on right front side of grate bar align-
ing cutout in bottom of log with grate bar. Make sure Log #3
touches Log #1.
4. Place back end of Top Middle Log #4 on Log #1. Press the side
of Log #4 up against raised area of Log #1. Align notch in front
end of Log #4 with grate bar.
5. Rest Top Right Log #5 on Log #3.
6. Align Top Left Log #6 with notches on Log #2 and Log #4.
41D2001
BV4536, BV5142 Natural Vent Gas Fireplace
Top Left Log
#6
Notch
Front Left Log
#2
Notch
Cutout for
Grate Bar
Figure 19 -
Log Placement
Top Middle Log
#4
Top Right Log
#5
Front Right Log
#3
Cutout for
Grate Bar
Rear Log
#1
LG603
21
Advertisement
Table of Contents
