Configuring Wireless Pcs; Positioning The Wireless Pcs; Wireless Pc Cards And Drivers; Configuring Pc Access To Your Wireless Device - Inteno FG101 User Manual

FG101 User's Guide

Configuring Wireless PCs

You need to configure the operating system installed on your Wireless PCs using the
same procedure described for Configuring Ethernet PCs section.

Positioning the wireless PCs

The wireless network cards used determine the maximum distance between your
wireless PCs and your device. Guidelines on positioning the hardware components of
your wireless network should be provided by your network card provider.

Wireless PC cards and drivers

Each PC on your wireless LAN must be fitted with a wireless access card. You must
also install the corresponding driver files for your particular wireless card on your PC.
You should receive driver files and instructions on how to install them together with
your wireless card.

Configuring PC access to your Wireless device

Before you start configuring your Wireless PC, you must ensure that you have:
A Wireless access card for each of the PCs
Corresponding wireless access card driver software files
The configuration steps below will vary depending on both the operating system and
wireless card installed on the PC. These steps provide a basic outline, however you
should refer to the documentation provided with your wireless access card for specific
instructions.
To configure Wireless PCs:
Install the wireless access card.
Install the wireless driver software files.
Configure the following wireless parameters on each of the wireless PCs:
• Set the adapter to use infrastructure mode. This configures the PCs to access each
other and the Internet via the device.
Configure the SSID and channel to match the SSID and channel previously
configured on the device.
Your wireless network can now communicate with the Internet via the device.
71