Testing Your Setup; Default Device Settings - Inteno FG101 User Manual

FG101 User's Guide

Testing your Setup

Once you have connected your hardware and configured your PCs, any computer on
your LAN should be able to use the device to access the Internet.
To test the connection, turn on the device, wait seconds till device booting up and then
verify that the LEDs are illuminated as follows:
Table 1: LED Indicators
If the LEDs illuminate as expected, test your Internet connection from a LAN computer.
To do this, open your web browser, and type the URL of any external website (such
as http://www.yahoo.com).
If the LEDs do not illuminate as expected, you may need to configure your Internet
access settings using the information provided by your ISP. If the LEDs still do not
illuminate as expected or the web page is not displayed, see Troubleshooting section
or contact your ISP for assistance.

Default device settings

The device is preconfigured with default settings for use with a typical home or small
office network.
The table below lists some of the most important default settings; these and other
features are described fully in the subsequent chapters. If you are familiar with
network configuration, review these settings to verify that they meet the needs of your
network. Follow the instructions to change them if necessary. If you are unfamiliar with
these settings, try using the device without modification, or contact your ISP for
assistance.
WARNING
LED Behavior
Power Solid red to indicate that the device is turned on. If
(PWR) this light is not on, check the power cable
attachment.
Wireless Solid green to indicate that the Wireless LAN
(WLAN) function is operational.
LAN Solid green to indicate that the device can
communicate with your LAN.
WAN Solid green to indicate that the device has
successfully established a connection with your ISP.
We strongly recommend that you contact your ISP prior to changing the
default configuration.
11