Lan - Inteno FG101 User Manual

FG101 User's Guide

LAN

Figure 22: LAN Configuration
To configure LAN:







Enter the IP address which the CPE in the LAN will use to connect to the device.
For example, enter 192.168.1.1
Enter the Subnet Mask. For example, enter 255.255.255.0
Check to Enable IGMP Snooping. This feature will snoop all of IGMP packets
and record related information. Therefore, multicast packets will be generated to
the related LAN ports only to avoid the packet flooding on all of LAN ports. Select
one of two modes, Standard mode or Blocking mode.
Select to Enable or Diable DHCP server. If it is enabled, please enter the DHCP
IP pool of Start IP address and End IP address. Enter the value of leased time in
hour about the valid period of assigned IP address. The DHCP server ON
(enabled) feature will enable this device to assign IP address automatically to PC
in LAN if PC requests an IP address by DHCP client protocol.
Select to Enable the DHCP Server Relay and enter the IP address of DHCP
server. The device will forward DHCP client request from PC to the DHCP server
and also forward the reply from DHCP server to PC too.
Check to enable and configure the second IP address and subnet mask for LAN
interface if there are two separated networks in the LAN sharing the device to
surf Internet. Then enter the second IP address and subnet mask.
Click Save to save setting or Save/Reboot to save and then reboot the device
22