Inteno FG101 User Manual page 27

FG101 User's Guide
To configure the IP over Ethernet settings:




Figure 21: Network Address Translation Configuration
Global Settings:







The WAN Setup Summary page shows all of parameters. Click Save if correct and
click Back to restart the configuration again.
Select "Obtain an IP address automatically" or "User the following (fixed) IP
address" and then also enter the WAN IP address and WAN Subnet Mask.
Select "Obtain default gateway automatically" or "User the following gateway"
and then also enter the gateway IP address and Use WAN Interface where
packets will be sent to.
Select "Obtain DNS server address automatically" or "User the following DNS
server addresses" and then also enter the IP addresses of Primary DNS server
and Secondary DNS server.
Click Next
Check to Enable NAT if PCs in the LAN share the same WAN port IP address to
surf Internet
Check to Enable Firewall if you need the device to do the first firewall protection
Check to Enable IGMP Multicast
Check to Enable WAN Service
Enter the Service Name
Enter the value of DHCP Option 60 (Vendor Class Identifier) if necessary
Click Next
21