Ppp Over Ethernet (Pppoe) - Inteno FG101 User Manual

FG101 User's Guide

PPP over Ethernet (PPPoE)

Figure 18: WAN Connection, PPPoE Configuration
To configure the PPPoE settings:









Enter the User's PPP Username and Password
Enter the Service Provider Name if any
Select the Authentication Method used during negotiation, default is AUTO.
Check "Dial On Demand" if you do not need PPPoE connection always ON and
enter the timeout value to disconnect the PPPoE connection when connection
is idle and timeout. If you enter "0", zero for the timeout value, it means always
ON.
Check the "IP extension" if your ISP requests to enable it, otherwise do not
select it. This is a special service to forward IP address assigned by remote to
the local device in the LAN.
Check the "Use Static IP address" and enter the IP address if your ISP assigns
a fixed IP address to you. Otherwise, do not select it.
Check the "Retry PPP Password on Authentication Error" if necessary
Check to "Enable PPP Debug Mode" to get more debug message for analysis if
necessary
Click Next
19