Routing; Default Gateway - Inteno FG101 User Manual

FG101 User's Guide










Routing

The section shows the IP addresses or address routes for the computers connected
to the gateway to reach different destinations, such as the local network, the gateway,
or the Internet. The Routing feature provides three more setting pages including
Default Gateway, Static Route and RIP.

Default Gateway

Figure 38: Default Gateway Configuration
Global Setting


NOTE: If changing the Automatic Assigned Default Gateway from "unselected" to
"selected", you must reboot the router to get the automatic assigned default gateway
Select the Physical LAN Port from the list which packets through this port will be
classified.
Select the Protocol from the list which packets with this protocol will be classified.
Select the Differentiated Service Code Point (DSCP) Mark Check from the list.
Enter the Source IP Address, Source Subnet Mask, and UDP/TCP Source Port
(single port or port range (Port:Port)).
Enter the Destination IP Address, Destination Subnet Mask, and UDP/TCP
Destination Port (single port or port range (Port:Port)).
Enter Source MAC Address and Source MAC Mask
Enter Destination MAC Address and Destination MAC Mask
Select the 802.1q Priority from the list.
Click Apply to add this QoS class
Check Enable Automatic Assigned Default Gateway checkbox, this router will
accept the first received default gateway assignment from one of the PPPoE or
Static IP/DHCP interface. If the checkbox is not checked, enter the static default
gateway AND/OR a WAN interface.
Click Save to save the configuration
32