FG101 User's Guide
Click Add to add a rule of Incoming IP Filtering.
Check Remove and click Remove to remove the specified entry.
Figure 32: Add - Incoming IP Filter Setup
Global Setting
Enter the Filter Name
Select the Protocol from the selection list.
Enter the Source IP Address and Subnet Mask (range of IP addresses) of packet
Enter the one port or multi ports (port range)
Enter the Destination IP Address and Subnet Mask (range of IP addresses) of
packet
Enter the one port or multi ports (port range)
Select the WAN interfaces which will be applied with this incoming IP filter rule.
Click Save/Apply
28