Motor; General Information - Cyclo Vac HD Series Owner's Manual

Motor

Please note that Cyclo Vac motors do not require lubrication. Each motor
contains two carbon brushes that will wear normally, and may eventually
require replacement. For warranty purposes, replacement should be done by an
authorized dealer. Brush life is affected by hours of use, frequency of start-ups
and shut-downs, humidity, altitude, and temperature. In order to avoid damage to
the unit's motor, brushes should be replaced before they are completely worn-out.
We therefore recommend that you have your unit and motors inspected by an
authorized dealer every 5-6 years.

General Information

If the unit does not work, check the fuse or breaker on the unit and/or in the
electrical panel of your home, and replace any defective part(s) as deemed
necessary. Please verify that the unit has been installed properly, according to the
instructions in this manual.
Your vacuum cleaning system is designed to collect everyday dry matter (dust).
It is approved by authorized testing agencies for dry use only. Do not use on wet
surfaces.
We strongly recommend against vacuuming abrasive materials such as cement,
plaster and gyproc dust. This fine dust could work its way into the motor, causing
considerable damage. Should you do so inadvertently, contact your authorized
service center to determine the extent of the damage to the unit.
Remember that in order for your warranty to remain valid, maintenance of the
motor and repairs to the unit itself must be carried out by an authorized service
center, using original Cyclo Vac or Trovac parts.
17