Maintenance; Motor; Electrostatic Bag - Cyclo Vac Ultra-Fresh Owner's Manual

Motor

Please note that Cyclo Vac motors do not require lubrication. Each motor
contains two carbon brushes which will wear normally, and may eventually require
replacement. For warranty purposes, this should be done by an authorized service
center. Brush life is affected by the number of hours used, frequency of start-ups
and shut-downs, humidity, altitude, and temperature. In order to avoid damage
to the motor itself, brushes should be replaced before they are completely worn
out. We therefore recommend that you have your unit and motors inspected by a
service center every 5-6 years.

Electrostatic Bag

Change the bag when the one in place
is full. Frequency will depend on use of
the unit. For the GX series,the integrated
monitor will indicate when to change the
bag. These indications are provided by an
electronic timing board, only as a reference
guide.
1. To access the bag, unlatch the two
clips and remove the dust receptacle
(fi gure 17).
2. Remove the used bag and seal bag
opening (adhesive seal provided on each
bag). Discard used bag.
3. Install the new bag, ensuring the tabs
on the bag adaptor are aligned with the
slots in the bag collar (fi gure 18).
4. Ensure adequate sealing by inserting
bag as far as the retention ring.
5. Replace dust receptacle and seal by
latching both clips.
Use only genuine Cyclo Vac replacement bags. Failure to
do so could void the warranty on your vacuum unit.
24
retention ring

Maintenance

fi gure 17
fi gure 18