NEC N8800-149F User Manual page 79

When the CPU module is stopped, the status LEDs change as follows. This indicates
that one CPU module is operating now.
[Indications of status when CPU module is stopped]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
*Here, an example where CPU module 0 is stopped is shown.
3.
Start the stopped CPU module.
Execute the following command to start the operation of the CPU module stopped in
step 2.
# cd /opt/ft/bin
# ./ftsmaint bringup 0
Once the CPU module is started, hardware diagnosis and then the duplication process
are performed.
Note that the system is paused temporarily for copying memory during memory
synchronization.
[Indications of status LEDs after completion of duplication]
1 PRIMARY LED
2 DISK ACCESS LED
3 System FT LED
IMPORTANT:
After duplication is completed, the status of memory will be checked.
Wait until this process ends to perform the next step (evaluation of start and stop of PCI
and CPU modules). When the process completes, the following event log will be output:
Kernel: EVLOG: INFORMATION – Memory consistency check has completed memory
scan.
LED
LED
LED
LED
ESX Operation and Configuration 3-13
Secondary
(Stopped) *
Green
Green
System
-
Secondary
(Operating)
Green
Green
System
Green
Primary
(Operating)
-
Green
Primary
(Operating)
-
Green