NEC N8800-149F User Manual page 65

To remove the optical disk, press the tray-eject button as you did in setting the optical disk.
When the access LED illuminates in green, it indicates the optical
disk is being accessed. Make sure the access LED is not
illuminating in green before you press the tray-eject button.
Press the locking part in the center of the tray and pick the optical
disk gently. When you have removed the optical disk, push the tray
to the drive-closed position.
When you cannot eject a Optical media.
When you cannot eject the optical disk from the server even by pressing the eject button, follow
the steps below to eject it:
1.
Press the POWER switch to power off this server (i.e. the
POWER LED is off).
2.
Use a metal pin of about 1.2 mm in diameter and 100 mm long
(alternatively, you can use a fairly large paper clip after
straightening). Insert it gently into the manual release hole
located at the low front side of the server until the tray is
ejected.
IMPORTANT:
Do not use a toothpick, plastic pin, or other breakable objects.
If you cannot eject the optical disk by following the steps above,
contact your sales agent.
3.
Hold the tray and pull it out.
4.
Take out the optical disk.
5.
Push the tray back.
General Description 2-29