NEC N8800-149F User Manual page 69

To operate the internal disk. it need to use the Kernel device names.
The kernel device name is decided by being detected by system when the disk is inserted or system
is booted. The kernel device name is displayed as "vmhbann0500:C0:Tx.L0".
The "nn" of "vmhbann0500:C0:Tx.L0" displays PCI Modules(10,11),and "x" that number more
than 0 are assigned by detection order displays target number.
You can confirm the kernel device name corresponding to the slot by using "/opt/ft/bin/ftsmaint"
command.
If you need to confirm the kernel device name of internal disk inserting in the slot2, carry out the
following command such as example.
# /opt/ft/bin/ftsmaint ls 10/40/2
H/W Path
Description
State
Op State
Reason
Modelx
Firmware Rev
Serial #
Device Name
Udev Device Names
Kernel Device Names
*In above example, the kernel device name is "vmhba100500:C0:Tx.L0".
Chart1 Slots corresponding to the mirroring process
Corresponding slot
Slot 0 (10/40/1)
Slot 1 (10/40/2)
Slot 2 (10/40/3)
Slot 3 (10/40/4)
Slot 4 (10/40/5)
Slot 5 (10/40/6)
Slot 6 (10/40/7)
Slot 7 (10/40/8)
: 10/40/2
: Disk Drive
: ONLINE
: DUPLEX
: NONE
: SEAGATE: ST973452SS
: 0005
: 3TA02A9M00009929YFLA
: disk_b
: -
: vmhba100500:C0:T1:L0
ESX Operation and Configuration 3-3
Slot 0 (11/40/1)
Slot 1 (11/40/2)
Slot 2 (11/40/3)
Slot 3 (11/40/4)
Slot 4 (11/40/5)
Slot 5 (11/40/6)
Slot 6 (11/40/7)
Slot 7 (11/40/8)