NEC N8800-149F User Manual page 76

3-10 ESX Operation and Configuration
3.
Stop the operation of the primary PCI module using the ftsmaint Command.
If the PCI Module 0 is primary, execute the following command.
# cd /opt/ft/bin
# ./ftsmaint bringdown 10 (*)
*As for the primary PCI Module(*),if the PCI Module 0 is primary select[PCI
Module(ID:10)].If the PCI module 1 is primary, select[PCI Module(ID:11)].
When you stop the operation of the primary PCI module, failover occurs and the
secondary PCI module becomes the primary module.
The PCI modules'status LEDs changes as shown below:
[Indications of status LED]
1
2 DISK ACCESS LED
3
*indicating primary or secondary after failover.
LED
PRIMARY LED
LED
System FT LED
Secondary*
-
-
(Green when accessing to HDD)
System
－
Primary*
Green
Amber or Green blinking