Command Mode - NTI UNIMUX-DVI-2 Installation And Operation Manual

NTI UNIMUX 2-Port USB DVI KVM Switch

Command Mode

Function: Keystroke:
Increment Port
Decrement Port
Toggle Scan Mode
ON and OFF
Sets scan time-out
period for each port.
Toggle Broadcast
Mode ON and OFF
Selects a specific
port
Select a different
control key combination
Select a specific
country code for
the keyboard
Print the code
version to a text
editor
Configure port to connect
To a MAC CPU
Configure port to connect
To a WINDOWS or SUN
CPU
Exit Command Mode
Default Value Reset
Default factory-set values for Command Mode entry key, Scan dwell time and country code can be restored by
following this procedure:
1. Disconnect power from the UNIMUX
2. Press and hold the CPU SELECT button on the switch
3. Re-connect power to the switch
4. Release the CPU SELECT button
NOTE: Command Mode not available on model UNIMUX-DVI-2-NBSC.
I
or
(select the next higher port
ex. 01
D or
(select the next lower port
ex. 02
(When toggled to ON, Scan Mode will be indicated the LED for only the active CPU
S
flashing ON and OFF .)
T -
-
(0-2)
x
(When toggled to ON, Broadcast Mode will be indicated by both LEDs cycling alternately
B
ON and OFF in rapid intervals.)
P -
0 -
(1-2)
C
-
x
x = the desired key (This will replace the Ctrl +
L -
-
x
V (This will print the version of the code in the UNIMUX to a text editor window for use
when troubleshooting the switch)
M (x= 1 or 2 <M> + <1> will enable function on Port 1
+ x
<M> + <2> will enable function on Port 2. Keyboard
LED's will flash once to confirm command. )
W (x= 1 or 2 <W> + <1> will disable function on Port 1
+
x
<W> + <2> will disable function on Port 2. Keyboard
LED's will flash once to confirm command. )
Note: The user must exit
Esc
Command Mode to use the CPU(s)
in the selected mode.
02)
or
+
-
01)
(xxx from 002 to 255. ie. t002
-
(0-9) (0-9)
would set the time-out period
x x
for 2 seconds)
(P0x would be P01 or P02.)
x
Command Mode)
x
(Lxx would be L00-L34, see Country Codes Table on page 11)
7
KEY SYMBOLS LEGEND:
PRESS EITHER KEY
CHORDED SEQUENCE- PRESS CONSECUTIVELY
AND KEEP KEYS PRESSED UNTIL ALL ARE PRESSED.
PRESS CONSECUTIVELY
`
sequence to enter