Data Process Menu - KoamTac KDC100 User Manual

Security Level(KDC350L): Allows you to ensure an accurate barcode reading by setting

the number of times the KDC will read a barcode. Security Level is set from 1 up to 4.
The higher security level means more reliable readings though some performance
degradation is likely. For poor quality barcodes, we recommend increasing the security
level. The default is 2.
Auto Trigger: Allows users to scan a barcode automatically once Auto Trigger is enabled.

User can adjust Reread delay from Continuous to Extra Long. Auto Trigger mode always
enables duplicate check option.
[Note1] USB cable insertion requirement is removed from FW2.85/86.O and FW 3.02.
[Note2] Users can exit the auto trigger mode by pressing the scan button for 3 seconds.
Reread Delay: Users can adjust Reread delay from Continuous to Extra Long. Auto

Trigger mode always enables duplicate check option.
Partial Display: Allows you to display partial data. User defines the start position and

number of characters to be displayed.

3.3.6 Data Process Menu

Wedge/Store - The KDC provides five modes of data transmission in keyboard wedging mode.
Wedge Only: Barcode data is NOT stored in memory but transmitted to the host.

Wedge & Store Only: Barcode data is stored in memory and transmitted to the host.

Store Only: Barcode data is stored in memory but NOT transmitted to the host.

Save if Sent: If data transmission is successful, barcode data is stored in memory.

Save if Not Sent: If data transmission is NOT successful, barcode data is stored in memory.

Data Format - The KDC provides two data formats, Barcode Only and Packet Data.
Barcode Only: KDC transmits scanned barcodes only. User may incorporate proper

data transmission error detection and correction mechanism in this mode.

KDC supports various termination
characters for barcode only format.
53
Revision 3.05.R6
Copyright ® 2013, KoamTac, Inc.
KDC User Manual