Installation; Bluetooth Pairing; Preparing For Pairing - KoamTac KDC100 User Manual

2 Installation

2.1

Bluetooth Pairing

KDC does not only read barcodes independently, but also when it is connected to PC, PDA, or
smart phones. Among different KDC models, particularly, KDC400 is designed to read barcodes
only when it is connected to smart phones or PDA since it does not have screen to show barcode
data.
You have to conduct pairing between your KDC and smart phone through Bluetooth only once.
Unless there are changes in Bluetooth settings, your smart phone will always recognize your KDC
that has already been paired. When you change Bluetooth settings, you need to go through
pairing process for your KDC again.

2.1.1 Preparing for Pairing

1.
In the case of KDC400, turn on the power first.
2.
Set a Bluetooth device type mode. There are two ways to set a Bluetooth device type mode.

Select and scan your Bluetooth device type barcode among the barcodes below, or
KDC 100/200/250/350L/410/415 (1D)
Bluetooth Device type
HID
Bluetooth Device type SPP2.0
Bluetooth Device type
SPP
Bluetooth Device type HID normal
23
KDC User Manual
iOS Bluetooth Device type
IPHONE
Revision 3.05.R6
Copyright ® 2013, KoamTac, Inc.