Operating The Kdc; Getting Started; Attach Lanyard/Hand Strap To Kdc; Charge Kdc Battery - KoamTac KDC100 User Manual

3 Operating the KDC

3.1

Getting Started

3.1.1 Attach Lanyard/Hand strap to KDC

To prevent possible damage to the KDC, we strongly recommend wearing it around your
neck or hand by the included Lanyard/Hand strap. Also, please don't swing KDC by the
Lanyard/Hand strap because contact with another object may cause it to malfunction or
become damaged.
To attach the Lanyard:
1. Fit the thin end of Lanyard through the pillar of the KDC.
2. Loop the thick end of strap through the thin loop
3. Pull the strap tight to secure

3.1.2 Charge KDC Battery

Prior to using the KDC, you must charge its battery. To charge the battery, follow these
directions.
1. Connect the KDC cable to the mini USB connector on the KDC.
Connect the KDC cable to Type A USB connector on your computer.
2.
3. Your KDC battery will begin charging. Within a few minutes, two small LEDs on the front
panel will illuminate orange. When the battery is fully charged, the LEDs will illuminate
green.
KDC100
2 Hours
KDC200
2 Hours
Table 2 – Approximate Time to Charge KDC Battery
KDC250/300 KDC350
4 Hours 5 Hours
37
Revision 3.05.R6
Copyright ® 2013, KoamTac, Inc.
KDC User Manual
KDC400
5 Hours