6.2
File Menu
6.2.1 Connect to KDC
The KDC connects to a COM port automatically when connected to your PC's USB port. You can
manually assign the KDC COM port using KTSync
needed.
The COM port assignment is found in the Windows Device Manager.
®
KTSync
will not connect to the KDC if it is in KDC Menus. You must EXIT from the
KDC Menus.
®
If KTSync
fails to connect automatically to the KDC, please follow these directions.
1. Exit KTSync
2. Check that you have connected the KDC to a USB port on your PC.
3. Make sure to use the cable provided with the KDC.
4. Check that the KDC is not in KDC Mode Menu.
5. Restart KTSync
NOTE: You can manually assign the COM port using KTSync
File menu.
6.2.2 Synchronize
Under the File Menu, this option allows you to manually synchronize data on KDC with host.
This option is similar to clicking on the Synchronize button in the KoamTac Data Synchronizer
box.
Figure 22 - COM Port Selection for KDC
®
.
®
.
80
®
Connection submenu under File menu if
®
Connect option under the
Revision 3.05.R6
Copyright ® 2013, KoamTac, Inc.
KDC User Manual