System Menu - KoamTac KDC100 User Manual

3.3.12 System Menu

Memory Size (3.0 version only)


User can select normal data and application database memory partition size.

KDC will erase all stored data upon changing the partition size.

User should enter the following key sequence to change the partition.

<Up key> + <Up key> + <Down key> + <Down key> + <Scan button>
Memory Status: Checks the number of stored barcodes and memory usage.

Reset Memory: Resets KDC memory by erasing all stored barcodes, application and BT

registry.
Auto Erase: Erases all stored barcodes upon reaching buffer full condition if Enabled is

selected
Sleep Timeout: Sets amount of time KDC waits, when not being used, before going to

sleep.
Auto Power Off (KDC250/350)


Bluetooth: Enabled/Disabled

GPS: Enabled/Disabled

Power Off Time:0(Never), 5, 10, 20, 30, 60, 120 minutes
Date/Time: Sets the date and time of KDC which can also be set using KTSync

Battery: Shows current status of battery power level.

Version: Shows KDC firmware version and serial number.

Button Lock: Locks or unlocks KDC scan and scroll buttons.

Beep Alert


Enables or disables KDC beep sound.
Beep Sound:

Power On Beep: Enables or disables beep sound when KDC power is on.

Beep On Connect: Enables or disables beep sound when KDC is connected to host.

Beep On Scan : Enables or disables beep sound when KDC is scanning.
Beep Volume: High or low.

MFi Mode (KDC200i, 250i, 300i, 350i, 400i): Enables or disables MFi mode. MFi mode

supports SPP and iPhone Bluetooth profiles. Non-MFi mode supports SPP, SPP2.0, HID iOS
and HID normal.
Vibrator: Enables or disables KDC vibrator.

Auto Exit: Enables KDC to automatically exit KDC Menus.

Port Status: Enables or disables KDC port messages.

Display Format: Selection of display format - Time & Battery, Type & Time, Type & Battery,

Memory Status and Barcode only
Menu Barcode: Enables or disables Honeywell special barcodes(KDC300/350C only)

Scrolling : Enables or disables display scrolling for a barcode with more than 40 characters

Brightness: Adjusts display brightness

Factory Default: Resets KDC options to factory default settings.

62
Revision 3.05.R6
Copyright ® 2013, KoamTac, Inc.
KDC User Manual
®