Data Process Menu - KoamTac KDC100 User Manual

the KDC will read a barcode. Security Level is set from 1 up to 4. The higher security level means
more reliable readings though some performance degradation is likely. For poor quality barcodes,
we recommend increasing the security level. The default is 2.
•
Auto Trigger: Allows users to scan a barcode automatically once Auto Trigger is enabled and USB
cable is connected. User can adjust Reread delay from Continuous to Extra Long. Auto Trigger
mode always enables duplicate check option.
•
Partial Display: Allows you to display partial data. User defines the start position and number of
characters to be displayed.

Data Process Menu

Wedge/Store - The KDC provides five modes of data transmission in keyboard wedging mode.
Wedge Only: Barcode data is NOT stored in memory but transmitted to the host.
Wedge & Store Only: Barcode data is stored in memory and transmitted to the host.
Store Only: Barcode data is stored in memory but NOT transmitted to the host.
Save if Sent: If data transmission is successful, barcode data is stored in memory.
• Save if Not Sent: If data transmission is NOT successful, barcode data is stored in memory.
Data Format - The KDC provides two data formats, Barcode Only and Packet Data.
Barcode Only: KDC transmits scanned barcodes only. User may incorporate proper data
transmission error detection and correction mechanism in this mode.
KDC supports various termination
characters for barcode only format.
User can select <NONE>, <CR>, <LF>,
<CR+LF> or <TAB> as the termination character.
Packet Data: KDC transmits packet data with checksum to minimize transmission errors.
KTSync
User may change Data Format to Barcode only if user prefers to use Barcode only
mode but either KTSync program terminates abnormally or user disconnects KDC
without exiting KTSync program normally.
®
sets Data Format to Packet Data format upon execution.
33
KDC100 User Manual