Lighting & Shutdown Procedures - kozy heat 911-XXL Installation & Operating Manual

L. LIGHTING & SHUTDOWN
NOTE: Prior to lighting, check all fittings for leakage. This is accomplished by applying soapy water on all
connections made. If there is any leakage, bubbles will appear at the point of connection. If bubbles occur,
tighten the fittings until the bubbles no longer appear.
IMPORTANT: TEST ALL CONNECTIONS WHETHER FIELD OR FACTORY MADE.
NOTE: The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of ½ psi.
NOTE: The appliance must be isolated from the gas supply piping system by closing its individual manual shut off valve during
any pressure testing of the gas line at test pressures equal to or less than 1/2 psig (3.5 kPa).
Pressure check taps for the manifold (outgoing) and inlet (incoming) pressures are located in front of the gas valve. The right
pressure tap is the manifold pressure and the left pressure tap is the incoming pressure. Follow instructions on page #21 for
check these pressures.
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A.
This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING, smell all around the appliance for gas.
Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in, or turn by
hand, don't try to repair it, call a qualified service
technician. Forced or attempted repair may result in a fire
or explosion, and loss of warranty.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
which has been under water.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
Refer to Figure L-1, page #20.
1. STOP! Read safety information above.
2. Open the lower grill by grasping the center of the top louver, then pull out and down to access
the gas valve.
3. Set the thermostat to the lowest setting. (If installed.)
4. Turn off all electric power to the appliance. (Fan.)
5. Push in black control knob (A) slightly and turn clockwise
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is pushed in slightly. Do not force.
6. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow the
safety information above. If you don't smell gas, go to the next step.
7. Find the pilot - follow metal tube from gas control. The pilot is behind the burner tube.
8. Turn the black control knob (A) on the gas valve counterclockwise
FOR YOUR SAFETY - READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
DUE TO HIGH SURFACE TEMPERATURES, KEEP
CHILDREN, CLOTHING AND FURNITURE AWAY.
This appliance needs fresh air for safe operation and
must be installed so there are provisions for
adequate combustion and ventilation air.
WHAT TO DO IF YOU SMELL GAS:
*Do not touch electrical switches.
*Do not try to light any appliance.
*Do not use any phone in your building.
*Follow the gas supplier's instructions
*Immediately call your gas supplier from a
neighbor's phone.
*If you cannot reach your gas supplier, call the fire
department.
to "OFF".
Page 19
to "PILOT".
Pilot