Konica Minolta bizhub 362 User Manual page 80

4
7
Touch [Subnet Mask] and enter the subnet mask address.
8
Touch [Gateway] and enter the default gateway address.
9
To apply the settings, restart this machine (turn the main power off,
then on again).
Turn this machine back on to apply the IP address.
Reminder
When turning the machine off, then on again with the main power switch,
wait about 10 seconds to turn the machine on after turning it off. The
machine may not operate correctly if it is turned on immediately after
being turned off.
!
Detail
Although the IP address is entered without using the DHCP server in the
procedure described here, it is also possible to automatically assign the
IP address from the DHCP server. When "DHCP Configuration" is set to
"Auto-Obtain", the IP address, subnet mask, and gateway address
settings are automatically assigned from the DHCP server on the
network, so it is not necessary to assign them manually. However, note
the following when setting "DHCP Configuration" to "Auto-Obtain".
Check with the network administrator that the DHCP server exists. If the
DHCP server does not exist, be sure to specify settings for "IP Address",
"Subnet Mask", and "Gateway Address".
If the settings for the IP address and other items have been assigned
using the DHCP server, there is a possibility that they may be
automatically changed. When the settings for the IP address and other
items are changed, if the IP address has been used to specify a printer
on the network for printing, there is a possibility that printing may not be
possible because this machine cannot communicate with the network. If
"DHCP Configuration" has been set to "Auto-Obtain", it is recommended
that the IP address assigned to this machine be fixed in the DHCP server
settings.
4-8
Setting up network printing
bizhub 362/282/222