Konica Minolta bizhub 362 User Manual page 393

Troubleshooting
Symptom
The stapling position is
not as expected.
The hole punch function
cannot be specified.
The pages are not
punched.
The hole punch position is
not as expected.
The form is not printed
properly.
The image is not printed
properly.
Paper is not fed from the
specified paper source.
The numbering function is
not performed.
Proof and Print is no be
performed.
bizhub 362/282/222
Probable cause
The orientation setting is not
correct.
Hole punching cannot be speci-
fied if "Booklet", "Transparen-
cy", "Thick2", "Thick3", or
"Envelope" is selected.
For the hole punch function, the
punch unit must be installed on
optional finisher.
Printed pages may be fed out
without being punched if the pa-
per is loaded into the paper
source with an incorrect orienta-
tion.
The orientation setting is not
correct.
Available computer memory
space is not sufficient.
Available computer memory
space is not sufficient.
Paper will not be fed from the
specified paper source if that
paper source is loaded with pa-
per of a different size or orienta-
tion.
The "Collate" (for Windows) or
"Collated" (for Mac OS X) check
box is selected on the print set-
up dialog box.
Action
Check the stapling position in
the printer driver setup dialog
box.
Check each setting in the printer
driver.
Install the required optional fin-
isher and enable it using the
printer driver.
Check the orientation setting.
Check the punch position on the
Layout tab of the printer driver
setup dialog box.
Simplify the form to reduce the
data size.
Simplify the image to reduce the
data size.
Load the paper source with pa-
per of the appropriate size and
orientation.
Clear the "Collate" (for Win-
dows) or "Collated" (for Mac OS
X) check box.
12
12-7